Do You Need to Flush a New Refrigerator Water Filter? What Each Brand Says
Part of our guide: Replacing and maintaining a filter 📌 Key takeaways The LG, Whirlpool and Samsung pages we read...
Part of our guide: Replacing and maintaining a filter
📌 Key takeaways
- The LG, Whirlpool and Samsung pages we read all describe running water through a new filter. Follow the manual for your model.
- The amounts differ by brand and model: about 2.5 gallons (LG), 2 to 3 or 4 gallons (Whirlpool). Samsung’s amount depends on the model.
- Cloudy water or black specks at first are expected from carbon dust, according to LG.
A new filter holds trapped air and fine carbon particles. Flushing clears them. The numbers below come from each brand’s support pages and can change between models, so follow your manual.
LG
LG says to run about 2.5 gallons (9.5 liters) through the new filter, in several rounds rather than all at once. One LG guide suggests 30 seconds on, 60 seconds off, for a total of 5 minutes. Expect cloudiness or black particles at first, from fine carbon particles inside the filter (LG support).
Whirlpool
Whirlpool’s blog says to run four gallons of water through the line to flush a new filter, then reset the light. An owner’s manual for an older model says to dispense and discard 2 to 3 gallons instead (Whirlpool). The two differ, so check the manual for your model.
Samsung
Samsung recommends flushing the new filter before you rely on it. The amount depends on the model. See Samsung’s replacement page for your model’s steps.
After flushing
- Reset the indicator light (how).
- Discard the first glasses if the water still looks cloudy.
- If flow stays slow, see the slow-flow checklist.
❔ FAQ
Is the cloudy water harmful?
LG describes it as air and fine carbon particles from the filter. We do not give health advice. If it does not clear after you have followed your manual, or if there is a lasting odor or taste, stop guessing and contact the manufacturer.
Does ice need flushing too?
Manuals often say to discard the first batch of ice. Check yours.
Next step: Check your refrigerator model in the filter finder.
This article was written by the MatchMyFilter editorial team from manufacturer support pages and published standards. We do not run lab tests. As an Amazon Associate I earn from qualifying purchases.
Why Carbon Fines and Trapped Air Occur
During shipping and initial dry storage, small microscopic particles of granular activated carbon can shed inside the cartridge chamber. Additionally, dry filtration pores trap ambient air. Flushing 3 to 4 gallons of water forces all trapped air pockets through the lines and settles the carbon matrix, ensuring crystal-clear, smooth dispensing and leak-free operation.
Troubleshooting Cloudy Water During Initial Flush
If the first two glasses of water appear cloudy or grayish, do not worry. This temporary discoloration is caused by harmless microscopic air bubbles escaping from the compressed dry carbon block, along with loose activated carbon dust fines. Continue dispensing water in 60-second intervals until the stream runs 100% clear. In almost all refrigerators, dispensing approximately 3 gallons completely clears the line.
More on this topic: Replacing a Refrigerator Water Filter: Steps, Timing and Aftercare
Related guides
Browse all refrigerator water filter guides
